MIL-T-14521E
3.7.1 Caution plate. A caution plate sitting no less than the following
shall be applied to the trestle on the same side as the handle.
CAUTION
DO NOT OVERLOAD STANDS.
PLACE LOAD ON CENTER OF SADDLE ONLY.
USE STANDS IN PAIRS, ON HARD LEVEL SURFACE.
LOAD AND STANDS SHALL BE STABLE.
STUDY , UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS.
FAILURE TO HEED THIS WARNING MAY RESULT
IN PERSONAL INJURY AND/OR PROPERTY DAMAGE.
MANUALLY ENGAE LOCKING PAWL PRIOR TO USE
The caution plate shall be fabricated of adhesive backed aluminum foil plate in
accordance with MIL-P-19634 or shall be metal plate, permanently fastened and
permanently marked.
3.8 Workmanship. Workmanship of the trestles and accessories shall be the
best quality prevailing among manufacturers commercially Producing and
marketing trestles of the type specified herein.
QUALITY ASSURANCE PROVISIONS
4.
4.1 Responsiblity for inspection. unless otherwise specified in the
contract, the contractor is responsible for the performance of all inspection
requirements (examinations and tests) as specified herein. Except as otherwise
specified in the contract, the contractor may use his own or any ether
facilities suitable for the performance of the inspection requirements specified
herein, unless disapproved by the Government.
The Government reserves the
right to perform any of the inspections set forth in the specification whet-e
such inspections are deemed necessary to ensure supplies and servicecs conform
to the prescribed requirements.
4.1.1 Responsiblity for compliance. All items must meet all requirements
of section 3 and 5. The inspection set forth in this specification shall
become a part of the contractor's overall inspection system or quality program.
The absence of any inspection requirements in the specification shall not
relieve the contractor of the responsibility of ensuring that all products or
supplies submitted to the Government for acceptance comply with all
requirements of the contract. Sampling in quality conformance does not
authorize submission of known defective material , either indicated or actual,
nor does it commit the Government to acceptance of defective material.
4.2 Classification of inspection.
The inspection requirements specified
herein are classified as follows:
(a)
First article inspection (see 4.2.1)
(b)
Quality conformance inspection (see 4.2.2)
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business